View of the mount

Sketch of the mount

The DP108S E9624 bracket has been designed to place a modern LCD or plasma monitor / television on a vertical wall. Its load capacity is 45 kg. This wall mount allows easy adjustment of tilt (without additional tools) in the range 15 degrees. It is also possible to rotate the panel (+/- 40 degrees) and adjust the distance from the wall.

The DP108S mount has additional screws protecting the flat panel against an attempt to take it off the wall.

The wall has to carry the load of the panel and the mount, including a wide margin of safety.

The mount cannot be installed on walls that do not provide firm hold (steel stud, old cinder block, plaster panel etc). If you are uncertain about the nature of the wall, consult an installation company.
The set contains all components needed for typical installation. In some specific conditions there may be required auxiliary elements or tools that should be supplied by professionals installing this type of hardware.
The basic required tools (not included): 3/16" drill bit, 1/2" masonry bit for brick / concrete block installations, electric drill, wrench or socket set, Phillips screwdriver.

Safety warning.

The set includes assembly instructions. If you do not understand those directions, or have any doubts about the safety of the installation, please call a qualified installer. Improper installation may cause damage or serious injury.
Before mounting check carefully to make sure there are no missing or defective parts. If you have any doubts do not begin installation.

Some operations should be performed by two skilled people!

Improper installation may cause damage or serious injury.
Do not use this product for any other purpose than specified.
Neither the producer nor distributor shall be liable for damage or injury caused by incorrect mounting, incorrect assembly, or incorrect use.

Name	Flat panel wall mount DP108S - tilt. swivel
Code	E9624
Screen size range	23” – 37”
Distance from wall	118-300 mm
FDMI / MIS	VESA
Load capacity	45 kg
Tilt adjustment	-15° to +15°
Rotation range	+/- 40°
Dimensions	525x350 (118-300) mm
Weight	10.5 kg