Hálózati elemek
Transzformátorok
4 csatornás aktív videó transzformátor Etrix 4VA-R vevő
Kód: M16745
Bruttó ár
Kedv.
Mennyiség
15165 Ft.
0 %
Front view
Rear view
View of the packaging
The active UTP video receiver is used to receive four video signals transmitted from complementary active video transmitter (Etrix 4VA-T M16744) via 8-wire CAT5e UTP cable over distances up to 2400 m, preserving original video quality.
The device matches the 100 ohm impedance of the balanced transmission lines (UTP cable) the impedance of the unbalanced inputs of a multiplexer, DVR etc. Used in video surveillance systems, the pairs of complementary devices allow efficient design of transmission lines without hard wiring.
The device matches the 100 ohm impedance of the balanced transmission lines (UTP cable) the impedance of the unbalanced inputs of a multiplexer, DVR etc. Used in video surveillance systems, the pairs of complementary devices allow efficient design of transmission lines without hard wiring.
LED indicators
- red: POWER
- green: VIDEO
Distinguishing features
- interference-free reception of four video signals
- the four channels use one 8-wire CAT5e UTP cable - it's cheaper and better solution than troublesome long coaxial lines
- maximum transmission distance 2400 m (using complementary active transmitter Etrix 4VA-T M16744)
- maximum transmission distance 1500 m (using a passive video transmitter)
- built-in anti-interference filters
The type of cable and connector wiring
A UTP cable rated CAT5 or higher is required. The quality of the cable used has a direct impact on the image quality and transmission range.
The wires should be connected (using a crimping tool, e.g. J9210) in accordance with the scheme TIA/EIA-586B for RJ-45 connectors. Coaxial cables terminated with BNC plugs are to be connected to the BNC sockets.
RJ-45 wiring
Settings
"Sharpness" DIP switch allows to adjust the receiver to the parameters of transmission line in order to get the best results. A suitable brightness level of the received video can be set with "Brightness" knob.
Application diagram
Specifications:
| Name | Etrix 4VA-R |
| Code | M16745 |
| Bandwidth | 0...8 MHz |
| Impedance of unbalanced outputs | 75 ohm |
| Impedance of balanced inputs | 100 ohm |
| Resistance of balanced lines (rated) | 18 ohm / 100 m |
| Differential capacity of balanced lines (max) | 62pf/m |
| Supported standards | NTSC, PAL, SECAM, CCIR |
| Power | 12 VDC / 160 mA |
| Operating temperature | -10...70 °C |
| Storage temperature | -30...70 °C |
| Dimensions | 204 x 103 x 49 mm (except for BNC sockets) |
Bruttó ár
Kedv.
Mennyiség
15165 Ft.
0 %
KIEGÉSZÍTŐK
KÖNYVTÁR ROVAT
ÚJAK KÖNYVTÁRUNKBAN
ÉRDEMES ELOLVASNI
Rövid útmutatónkban azoknak szeretnénk segítséget adni, akik jó vételi körülmények között szeretnék egyedül megoldani az antennatelepítést. Az olyan... bővebben »